You sacrificed a lot of money to purchase a good washing machine, a washer that can give you the kind of service you need, and for a long time. Somehow, it has started developing minor complications, for example, it won't drain water, it's not spinning, it's leaking, it's unusually noisy, or even worse; it won't start. Worst case scenario; you have a load of dirty clothing to clean. Appliance Repair Santa Ana is only a call away at (949) 670-2111.
Let's face it; washing machines are expensive, and you won't be buying a new one every time you notice a fault with the one you have at home. It's far much cheaper and convenient to get it repaired by experts instead of disposing it and going for a brand new machine, otherwise you'll end up with a garage of washing machines at your backyard. Appliance Repair Santa Ana has the right people who will get your washer working normally, like there was no problem in the first place.
The most typical kind of washing machine service is for loud sounds from the machine. A professional can detect the source of the loud noise and decide whether he may need to service or replace the in poor condition parts. The cause of the sound is frequently caused by a damaged pump motor or worn in belt or bearings.
WON’T TURN ON/AGITATE
Whenever your washer won’t switch on, first determine whether it is unplugged or if a circuit breaker flipped off. The issue could also be due to a broken door latch, thermal fuse or timer. A washer that won’t agitate indicates the agitator cogs, coupler, drive belt or transmission require repair or replacing.
A washer that won’t spin means there is a problem with the wax motor, door latch or motor coupling. There are numerous Santa Ana appliance service businesses that can repair these issues in no time at all and have your washing machine spinning again ASAP! We can find the right one for you!
The frequent causes for a washing machine overflowing is the water inlet valve, water level pressure switch or the air dome tube on the appliance.
NO HOT/COLD WATER
A broken temperature control switch or inlet tube is often the main reason why a washing machine will never make cold or hot water.